Note: Do not start the machine. Contact your authorized Toro Service gets off machine. Driving on the street or roadway without turn signals, lights, reflective markings, or a slow-moving-vehicle emblem is dangerous and can lead to accidents, causing personal injury. Measure from a level blade. If the engine stalls or hesitates, move the choke Disengaging the Blades lever partially forward for a few seconds Figure 11. Fuel vapors are flammable and explosive.
Inflate the front caster wheel tires to 103 kPa 15 psi. Air is required to thoroughly cut grass clippings, so do not set the height-of-cut so low as to totally surround the mower in uncut grass. The engine does not start, starts hard, or fails to keep running. Wash the foam element with water and replace the foam element if it is damaged. Failure to comply with these instructions may result in personal injury or death.
. The following table lists some of the common causes of trouble. Foot pedal deck lift and height-of-cut G010009 Figure 4 1. Grease the front caster pivots and wheels Figure 22. Important: Do not clean the paper element with pressurized air or liquids, such as solvent, gasoline, or kerosene. Mowing on wet grass or steep slopes can cause sliding and loss of control.
Note: The machine must be on a level surface for the following procedure. The brake lever engages a parking brake on the drive wheels. Recycle as per local codes. Charging the Battery Figure 31 1. Using a spring removal tool, Toro part no.
Clean the air intake screen from grass and debris before each use. Contact with hot surfaces may cause personal injury. Level surface Note: The machine must be on a level surface for the 3. I added a little 20w50, as noted in the manual and nothing. Remove the nut, bolt, and pivot bushing from the deck strut Figure 47. Battery terminals or metal tools could short against metal machine components causing sparks.
Check the hydraulic oil every 25 hours maintenance. To disengage the parking brake, pull the lever out of the detent slot and toward you, then push it down. It is not designed for cutting brush or for agricultural uses. Contact an Authorized Toro Dealer for service. Check the mower deck for bent blades prior to leveling; remove and replace any bent blades; refer to before continuing. Contact any Authorized Toro Service Dealer to obtain the proper High Altitude Kit and high-altitude label for your machine.
Oil level in the crankcase is low. If you cannot mow for an extended period, first mow at a high cutting height, then mow again 2 days later at a lower height setting. Red + Charger Lead 2. Be careful when removing the belt. Thrown object hazard, mower—do not operate without the deflector, discharge cover, or grass collection system in place. Note: If the mower is not clean after 1 washing, soak it and let it stand for 30 minutes. To minimize the chance of varnish deposits in the fuel system, use fuel stabilizer at all times.
No other blades are approved. Note: If the front blade tip is not 1. Move throttle to full forward position before 3. Install the fasteners removed previously at the front discharge performance and can obtained from your holes in the discharge plate and forward hole in the local authorized Toro dealer. Wear eye protection; smoking explosive gases can cause blindness and other injuries.
If you have a lot of firewood to cut or clearing to do, get some extra chains. Always follow all safety instructions to avoid serious personal injury. Lift the deflector up to test that it snaps to the full down position. A broken or missing washout fitting could expose you and others to thrown objects or blade contact. Remove the floor pan to access the idler pulley; refer to the Removing the Floor Pan procedure in Premaintenance. Tearing and shredding turns grass brown at the edges, which slows growth and increases the chance of disease. If the front of the mower is more than 7.