The defibrillator will automatically turn off the pacer and start charging. Fixed Mode Pacing When in fixed mode, the pacer will deliver pacer pulses at the selected pacer rate. Charge Time: Less than 5 seconds to 360 joules with a fully charged battery installed. Have the cable set tested for electrical continuity every three months. Patient Movement Make sure that the application site chosen does not move excessively, which may adversely affect the performance of the sensor. Size and Weight of the CodeMaster 100 without the 12-Lead Option Defibrillator dimensions: 6.
From the Main Menu you can perform several functions. This adapter cable allows defibrillation through multifunction defib electrodes. Output Energy Delivered : Available protocol 200J, 200J, 360J and 200J, 300J, 360J. Using any other patient cable may compromise defibrillation protection as well as performance. Turn the Energy Select control to the Monitor On position.
Hewlett-Packard recommends that you not change any default settings if you are using the internal modem or a Hayes-compatible external modem. Enter data for patient information. Charge buttons are located on the front panel of the CodeMaster 100 and on the apex paddle. Default values are shown in boldface type. Paddle cord is 10 feet 3 m.
Visually check the patient cables, paddles, cables, and pads adapter cables for wear, insulation nicks, and other damage. Always request that local safety personnel verify that multiple connected equipment comply with local requlatory standards before putting such equipment into service. Do not use bleach or wring. Table 6-6 Basic Measurements Item Description. Figure 1-9 illustrates the placement of the controls.
Register a Free 1 month Trial Account. If this number fails, the Alternate gateway number will be used. Table 1-1 lists audible indicators. Charge 3-3 Resetting the Selected Energy Level 3-4 3. Stop when you see the alarm you would like to choose and after three seconds that alarm will take effect.
Charge-Done Indicator: Display indicates available energy, charge-done light on apex paddle, charge done tone. This topic provides details for each indicator. Non-invasive pacing, as a therapy, is indicated for use in patients with symptomatic bradycardia or asystole. Print the Configuration When you select this entry, the system will print the current configuration. Move the Energy Select control to the new energy level. Use the Sensor Guide to find the sensor which is best for your case. Paddle cord is 10 feet 3m.
Normal readings in a healthy adult, however, range from 94% to 100%. The pacer provides demand synchronous and fixed asynchronous pacing modes. Output energy delivered : 2, 3, 5, 7, 10, 20, 30, 50, 70, 100, 150, 200, 300 and 360 joules. Use the procedure as described in Table 2-2 on page 2-12 to set up the patient cable type 3-wire, 5- wire, 10-wire. Use F3 to change a field. Dangerous high voltages can be exposed.
Payment Payment is due within 3 days through Paypal, Wire Transfer and Credit Card by phone. Press SpO alarm repeatedly to cycle through the alarm options and the no- alarm option. Refer to the packaging provided with the paddles for placement and usage guidelines. The system then confirms the number it is dial- ing and that the sequence is being sent. Table 12-10 Transmission Problems and Solutions Message Likely Cause Possible Solutions 12-17.
To avoid risk of electrical shock, do not allow the electrolyte medium to accumulate on your hands or on the paddle handles Use of a defibrillator in the presence of flammable agents or in an oxygen enriched atmosphere presents an explosion and fire hazard. Repeated charging to less than 100% will reduce the useful life of the battery. The purchaser agrees that the seller shall not be held responsible or liable for any injuries or damages, whether incidental or consequential, associated in any way with the equipment. Remove the battery from the defibrillator by pinching the latch and pulling the battery out and up. Refer to Figure 6-1 for an illustration of the 12-Lead keyboard. Machine wash the carry bag in cold water with a mild detergent. It also details setup, configuration, and troubleshooting procedures.